Wiring Methods : tears of three lines , namely red , black , yellow line . black line is the red line yellow line shared negative , direct and control the car connected to the negative line of small lights , small lights positive red wire car , yellow car turn signal wire to the cathode . Achieved when the car turned on a small lamp light bar glows white , turn on the turn signal is yellow ( turn signal ) .Products can be cut as needed , specific steps : cut from the beginning from the end , three lights a cut ( three lights as a loop , if only cut one , the other two lights are not lit ); after hair cut incision must be on an insulating plastic , otherwise it will cause a short circuit light bar , light bar once short-circuit is equal to the direct scrapped !
Application: Angel eye, headlight turning light
Note: When light up the amber yellow color, it will be light up the white color in a very short time
Can dress up the headlights similar to the new Audi Style.
Waterproof-both for Interitor & Exterior of Car use, simply installation.
Install Example: Connect the White LEDs wire to the night driving light and the Yellow LEDs wire to the Turn signal light 1. At daytime, night driving light is off, the Yellow LEDs use as the turn signal light 2. At night, the white LEDs light on, the Yellow LEDs on when turn signal light on, very very good looking!!
Use for any 12V DC vehicles, require right connect to the positive(+) and negative(-) side.
Purpose: Wide use to Auto / Motorcycle / Home / House Decoration... Exterior Decoration: Angel Eye Light, Daytime Running Lights, Turn Signal Lights, Eyebrow Lights, Net Lights, Chassis Lights, Wheel lights, Running Lights, Brake Lights, License Frame Lights, Rear Window Lights... Interior Decoration: Floor Lights, Pedal Lights, Brake Lights, Trunk Lights, Door Lights, Instrument Lights, Car Dome Lights, Interior Decoration Lights...
Electronic components with environmentally friendly materials.
Light Color: Show White/Amber Yellow Light
2 x 85CM Soft LED Strip Light
Use spaces to separate tags. Use single quotes (') for phrases.